Batch handling 10 tons pyrolysis plant
Basic Info
Model No.: LJ-10
Product Description
Batch handling 10 tons pyrolysis plant
Introduction of Batch handling 10 tons pyrolysis plant
This plant does not have to get rid of silt, moisture content, iron wire impurity and so on from the scrap plastic, directly loads in the rotary system high temperature atmospheric pressure split processor, catalyses, heats up, distils oil steam, the oil gas through the condenser, the liquefied part condense into the oil mixture, and the unliquefied part holds through the fuel gas system into the processor bottom to burn.After the mixture oil condense, put into fractionation processor to heat though catalytic reforming process, and get the oil steam. Then the oil steam through the condenser to be basic fuel, and add various additives to become qualified fuel.
Processing of Batch handling 10 tons pyrolysis plant
First, the raw materials are put into the reactor, and then seal the feeding in door, later start the machine and the reactor will be rotating and heated by coal, natural gas, wood or electricity. When the temperature reaches the degree of 250 to 280, we will get the crude oil, the oil steam will be continuous produced until the temperature reaches 350-460°C; oil steam will flow through oil gas separator, light component will enter the condensers and meanwhile the heavy oil will be discharged automatically into in heavy oil tank. The liquefied part will be condensed AS crude oil, and the part which cannot be liquefied will be transferred by the water seal back to the burning chamber to be reused as heating material.
Technical parameter
| Model | Raw material | Structure form | Cooling system |
| LJ-10 | waste tire, plastic,rubber | Horizontal | water cooling |
| Heating method | oil output rate | Power | Installation |
| Directly | 45% | 15.5KW | Foundation |
Security of Batch handling 10 tons pyrolysis plant
The main equipment is of high safety. The phase of the unliquefizable waste gas produced during the process is alkyl from C1 to C4, which is dangerous when burning directly. In our process, it is transferred first through a water seal device and a safety device- burning air muzzle. Before burning, we should ensure the safety of production.
Land requirement:
10M*30M(300meter square) is needed to install the pyrolysis unit.
This equipment only needs 2 or 3 people to operate it.
Delivery time:
Around 20 days
Payment terms:
T/T. 30% advanced;70% before shipping
Product Categories : Waste Tire Pyrolysis Plant